Brass ring tee coupling
Part Number:
16 - 63 mm, 16 bar | 125
Applications:
Isiflo coupling system for plastic pipes gives a tight and end-load resistant connection and can be used on:
· MDPE: BS6572 and BS6730
· Black poly: All classes, and BS3284
· Copper: Table X & Y
· Lead: BS602 and BS1085
· Galvanised steel: BS1387, BS3601 and BS3602 part 1 & 2. (only type 142)
· PVC: BS3505
· PEX: support insert has to be used
Important:
Insert shall be used on thin-walled PE pipes (for example SDR 17,6, on geothermal heat pumps etc.)
Assembly instruction:
· Cut the pipe, deburr.
· Loosen the nut, do not dismantle
· Mark insert distance (P) and push the pipe to the stop
· Tighten the nut against the body.
Important:
A good seal is only obtained when the pipe is pushed past the O-ring, up to the pipe stop and the nut is tightend against the body.
When using Isiflo coupling on cupper or steel pipes, shall the pipe always be installed with a clearance of approx. 3 mm from the internal stop.
Isiflo coupling system for plastic pipes gives a tight and end-load resistant connection and can be used on:
· MDPE: BS6572 and BS6730
· Black poly: All classes, and BS3284
· Copper: Table X & Y
· Lead: BS602 and BS1085
· Galvanised steel: BS1387, BS3601 and BS3602 part 1 & 2. (only type 142)
· PVC: BS3505
· PEX: support insert has to be used
Important:
Insert shall be used on thin-walled PE pipes (for example SDR 17,6, on geothermal heat pumps etc.)
Assembly instruction:
· Cut the pipe, deburr.
· Loosen the nut, do not dismantle
· Mark insert distance (P) and push the pipe to the stop
· Tighten the nut against the body.
Important:
A good seal is only obtained when the pipe is pushed past the O-ring, up to the pipe stop and the nut is tightend against the body.
When using Isiflo coupling on cupper or steel pipes, shall the pipe always be installed with a clearance of approx. 3 mm from the internal stop.
Ask for information
For more information, please fill out the below form.